On Fri, Dec 2, 2016 at 1:14 AM, Anand Jain <anand.jain@xxxxxxxxxx> wrote:
>
> Hi,
>
> I didn't add umount at end of the test because...
> _check_btrfs_filesystem() does it, which gets called as this test does not
Nop it doesn't.
See common/check:
_check_filesystems()
{
if [ -f ${RESULT_DIR}/require_test ]; then
_check_test_fs || err=true
rm -f ${RESULT_DIR}/require_test
fi
if [ -f ${RESULT_DIR}/require_scratch ]; then
_check_scratch_fs || err=true
rm -f ${RESULT_DIR}/require_scratch
fi
}
Those files are created by the _require_scratch and _require_test
functions, which are not called by btrfs/12[45].
> specify _require_scratch_nocheck
>
> ----------------
> _check_btrfs_filesystem()
> {
> device=$1
>
> # If type is set, we're mounted
> type=`_fs_type $device`
> ok=1
>
> if [ "$type" = "$FSTYP" ]
> then
> # mounted ...
> mountpoint=`_umount_or_remount_ro $device` <----
> fi
>
> btrfsck $device >$tmp.fsck 2>&1
> ----------------
>
>
> I faced the similar problem on some other tests and I found
> adding the delay is the right approach. for eg:
>
> --------------------------
> diff --git a/tests/generic/298 b/tests/generic/298
> index e85db1266fa9..4092efa6b961 100755
> --- a/tests/generic/298
> +++ b/tests/generic/298
> @@ -92,7 +92,7 @@ echo "reflink of $n bytes took $delta seconds" >>
> $seqres.full
> test $delta -gt $timeout && _fail "reflink didn't stop in time, n=$n
> t=$delta"
>
> echo "Check scratch fs"
> -sleep 2 # give it a few seconds to actually die...
> +sleep 40 # give it a few seconds to actually die...
That might work for that test, but certainly not for btrfs/12[45] as
mentioned above.
Besides, that's a terrible solution. What guarantees you have that 40
seconds is enough for everyone...
thanks
>
> # success, all done
> status=0
> --------------------------
>
>
> HTH
> -Anand
>
>
>
>
> On 11/24/16 14:25, fdmanana@xxxxxxxxxx wrote:
>>
>> From: Filipe Manana <fdmanana@xxxxxxxx>
>>
>> The tests mount the second device in the device pool but never unmount
>> it, causing the next test to fail.
>>
>> Example:
>>
>> $ cat local.config
>> export TEST_DEV=/dev/sdb
>> export TEST_DIR=/home/fdmanana/btrfs-tests/dev
>> export SCRATCH_MNT="/home/fdmanana/btrfs-tests/scratch_1"
>> export SCRATCH_DEV_POOL="/dev/sdc /dev/sdd /dev/sde /dev/sdf /dev/sdg"
>> export FSTYP=btrfs
>>
>> $ ./check btrfs/125 btrfs/126
>> FSTYP -- btrfs
>> PLATFORM -- Linux/x86_64 debian3 4.8.0-rc8-btrfs-next-35+
>> MKFS_OPTIONS -- /dev/sdc
>> MOUNT_OPTIONS -- /dev/sdc /home/fdmanana/btrfs-tests/scratch_1
>>
>> btrfs/125 23s ... 22s
>> btrfs/126 1s ... - output mismatch (see
>> /home/fdmanana/git/hub/xfstests/results//btrfs/126.out.bad)
>> --- tests/btrfs/126.out 2016-11-24 06:11:42.048372385 +0000
>> +++ /home/fdmanana/git/hub/xfstests/results//btrfs/126.out.bad
>> 2016-11-24 06:16:35.987988895 +0000
>> @@ -1,2 +1,5 @@
>> QA output created by 126
>> -pwrite: Disk quota exceeded
>> +ERROR: /dev/sdc is mounted
>> +mount: /dev/sdc is already mounted or
>> /home/fdmanana/btrfs-tests/scratch_1 busy
>> + /dev/sdc is already mounted on
>> /home/fdmanana/btrfs-tests/scratch_1
>> +/home/fdmanana/btrfs-tests/scratch_1/test_file: Disk quota exceeded
>> ...
>> (Run 'diff -u tests/btrfs/126.out
>> /home/fdmanana/git/hub/xfstests/results//btrfs/126.out.bad' to see the
>> entire diff)
>> Ran: btrfs/125 btrfs/126
>> Failures: btrfs/126
>> Failed 1 of 2 tests
>>
>> So just make sure those test unmount the device before they finish.
>>
>> Signed-off-by: Filipe Manana <fdmanana@xxxxxxxx>
>> ---
>> tests/btrfs/124 | 1 +
>> tests/btrfs/125 | 1 +
>> 2 files changed, 2 insertions(+)
>>
>> diff --git a/tests/btrfs/124 b/tests/btrfs/124
>> index 2618a26..7206094 100755
>> --- a/tests/btrfs/124
>> +++ b/tests/btrfs/124
>> @@ -159,6 +159,7 @@ if [ "$checkpoint1" != "$checkpoint3" ]; then
>> echo "Inital sum does not match with data on dev2 written by
>> balance"
>> fi
>>
>> +$UMOUNT_PROG $dev2
>> _scratch_dev_pool_put
>> _test_mount
>>
>> diff --git a/tests/btrfs/125 b/tests/btrfs/125
>> index 1062b87..91aa8d8 100755
>> --- a/tests/btrfs/125
>> +++ b/tests/btrfs/125
>> @@ -175,6 +175,7 @@ if [ "$checkpoint1" != "$checkpoint3" ]; then
>> echo "Inital sum does not match with data on dev2 written by
>> balance"
>> fi
>>
>> +$UMOUNT_PROG $dev2
>> _scratch_dev_pool_put
>> _test_mount
>>
>>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
