Run xfs_repair twice at the end of each test -- once to rebuild
the btree indices, and again with -n to check the rebuild work.
Signed-off-by: Darrick J. Wong <darrick.wong@xxxxxxxxxx>
---
README | 4 ++++
common/rc | 30 ++++++++++++++++++++++++++++++
2 files changed, 34 insertions(+)
diff --git a/README b/README
index 2647e12..4509cc1 100644
--- a/README
+++ b/README
@@ -80,6 +80,10 @@ Preparing system for tests (IRIX and Linux):
added to the end of fsstresss and fsx invocations, respectively,
in case you wish to exclude certain operational modes from these
tests.
+ - set TEST_XFS_REPAIR_REBUILD=1 to have _check_xfs_filesystem
+ run xfs_repair -n to check the filesystem; xfs_repair to rebuild
+ metadata indexes; and xfs_repair -n (a third time) to check the
+ results of the rebuilding.
- or add a case to the switch in common/config assigning
these variables based on the hostname of your test
diff --git a/common/rc b/common/rc
index 7c79bf8..3b45578 100644
--- a/common/rc
+++ b/common/rc
@@ -2428,6 +2428,36 @@ _check_xfs_filesystem()
ok=0
fi
+ if [ -n "$TEST_XFS_REPAIR_REBUILD" ]; then
+ $XFS_REPAIR_PROG -n $extra_options $extra_log_options $extra_rt_options $device >$tmp.repair 2>&1
+ if [ $? -ne 0 ]
+ then
+ echo "_check_xfs_filesystem: filesystem on $device is inconsistent (r) (see $seqres.full)"
+
+ echo "_check_xfs_filesystem: filesystem on $device is inconsistent" >>$seqres.full
+ echo "*** xfs_repair -n output ***" >>$seqres.full
+ cat $tmp.repair | _fix_malloc >>$seqres.full
+ echo "*** end xfs_repair output" >>$seqres.full
+
+ ok=0
+ fi
+ rm -f $tmp.fs_check $tmp.logprint $tmp.repair
+
+ $XFS_REPAIR_PROG $extra_options $extra_log_options $extra_rt_options $device >$tmp.repair 2>&1
+ if [ $? -ne 0 ]
+ then
+ echo "_check_xfs_filesystem: filesystem on $device is inconsistent (r) (see $seqres.full)"
+
+ echo "_check_xfs_filesystem: filesystem on $device is inconsistent" >>$seqres.full
+ echo "*** xfs_repair -n output ***" >>$seqres.full
+ cat $tmp.repair | _fix_malloc >>$seqres.full
+ echo "*** end xfs_repair output" >>$seqres.full
+
+ ok=0
+ fi
+ rm -f $tmp.fs_check $tmp.logprint $tmp.repair
+ fi
+
$XFS_REPAIR_PROG -n $extra_options $extra_log_options $extra_rt_options $device >$tmp.repair 2>&1
if [ $? -ne 0 ]
then
--
To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
