Wolfgang Mader posted on Sun, 26 Apr 2015 20:39:34 +0200 as excerpted: > Hello, > > I have a raid10 with one device missing. I would like to use btrfs > replace to replace it. However, I am unsure on how to obtain the devid > of the missing device. The devid is if the device is still active in the filesystem. If it's missing... btrfs device delete missing That, along with a bunch of other likely helpful information, is covered on the wiki: https://btrfs.wiki.kernel.org Specifically for that (reassemble from the wrap, too lazy to fiddle with it on my end): https://btrfs.wiki.kernel.org/index.php/ Using_Btrfs_with_Multiple_Devices#Replacing_failed_devices But since it was a four-device raid10 and four devices is the minimum for that, I don't believe it'll let you delete until you device add, first. Of course that means probably some hours for the add, then some more hours for the delete missing, during which you obviously hope not to lose another device. Of course the sysadmin's backup rule of thumb applies -- if you don't have a backup, by definition, loss of the data isn't a big deal, or you'd have it backed up. (And the corollary, it's not a backup until it's tested, applies as well.) So you shouldn't have to worry about loss of a second device during that time, because it's either backed up or the data isn't worth the trouble to backup and thus loss of it with the loss of a second device isn't a big deal. That page doesn't seem to cover direct replacement, probably because the replace command is new and it hasn't been updated. But AFAIK replace doesn't work with a missing device anyway; it's the fast way to replace a still listed device, so you don't have to add and then delete, but the device has to still be there in ordered to use that shortcut. (You could try using missing with the -r option tho, just in case it works now. The wiki/manpage is a bit vague on that point.) > Btw, the file system is too old for skinny metadata and extended inode > refs. If I do a btrfs replace or a btrfs device add, must I myself > ensure that the new features are not enables for the new device which is > to be added? I don't believe there's any way to set that manually even if you wanted to -- you don't use mkfs on it and the add/replace would overwrite existing if you did. The new device should just take on the attributes of the filesystem you're adding it to. -- Duncan - List replies preferred. No HTML msgs. "Every nonfree program has a lord, a master -- and if you use the program, he is your master." Richard Stallman -- To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
