I'm copying an image of a 2G microSD card to a BTRFS filesystem. The SD card is from an Android phone and is almost full of Android packages and photos, there's very little space on the filesystem and what space there is probably isn't filled with zeros. # ls -l total 888000 -rw-r--r--. 1 root root 1043529728 Apr 10 11:20 2gsd While doing it I run ls commands to see the progress and get output like the above. Why is the file size according to ls not matching the total used? # du -h 886M . When I ran du immediately afterwards it also reported that there was less than 1G used. # du -h 1.2G . # du -h 1.2G . # du -h 1.1G . # du -h 1.1G . # du -h 1.1G . # du -h 1.2G . # du -h 1.2G . Above are some consecutive du runs. Why does the space used go from 1.2G to 1.1G before going up again? The file was created by "cat /dev/sde > 2gsd" so it definitely wasn't getting smaller. What's going on here? -- My Main Blog http://etbe.coker.com.au/ My Documents Blog http://doc.coker.com.au/ -- To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
