Re: MyGica V2V Pro

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

On Fri, Jan 27, 2012 at 12:33 AM, Matthew Barnes <mbarnes@xxxxxxxxxx> wrote:
> I have an older Dell workstation with an integrated Intel i865 running
> Debian Testing with XOrg 7.6.
> Recently I got a MyGica V2V Pro [1] video to VGA converter so I can play
> games from an old game console on my LCD monitor.  It has a VGA passthru
> so I can switch between my PC and the game console or other video device
> device on-the-fly.
> However when I boot the machine with this V2V device between the PC and
> monitor, I see the BIOS screen flash by and the kernel start to load,
> but then when it tries to do a mode switch the monitor goes into power
> save mode and never comes back.
> When the PC and monitor are connected directly, everything works fine.
> Figuring the V2V device is interfering with the intel driver's EDID
> probe, I thought if I captured my working configuration and hard-coded
> it in /etc/X11/xorg.conf, then the X server would have everything it
> needed to know without probing the monitor.
> So I ran "Xorg -configure" to get a base xorg.conf and then replaced the
> "Monitor" section with the output of "get-edid | parse-edid".  But the
> intel driver seem to want to probe EDID regardless.
> Attached is my xorg.conf and a diff of two Xorg logs -- one WITH the V2V
> device attached and showing failures (-), and another WITHOUT the V2V
> device attached and showing normal operation (+).
> Hoping for some advice on what I'm doing wrong or what to try next.

try adding video=1024x768 on the kernel command line.

xorg@xxxxxxxxxxx: X.Org support
Your subscription address: list-xorg@xxxxxxxxxxx

[X Forum]     [Nouveau Driver]     [Devices]     [XFree86]     [XFree86 Newbie]     [Site Home]     [IETF Annouce]     [Security]     [Fontconfig]     [Bugtraq]     [Photo]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Video for Linux]     [Linux RAID]     [Linux Resources]

Powered by Linux