Re: SiS Direct rendering

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Marcial Vieira wrote:
I tryed to configure my SiS 630 on-board with linux but 3D never worked, glxinfo always output:

direct rendering: No

But XFree86.1.log has:
(II) SIS(0): [drm] installed DRM signal handler
(II) SIS(0): [DRI] installation complete

(II) SIS(0): [drm] installed DRM signal handler
(II) SIS(0): [DRI] installation complete
(II) SIS(0): Direct rendering enabled

What's wrong?

Based on the fact that glxinfo shows GLX version 1.4 is supported, you must have installed the software libGL from Mesa. You need the libGL that came with XFree86 to get hardware acceleration. Uninstall the Mesa library and put the original one back.


_______________________________________________
XFree86 mailing list
XFree86@xxxxxxxxxxx
http://XFree86.Org/mailman/listinfo/xfree86

[Index of Archives]     [X Forum]     [Xorg]     [XFree86 Newbie]     [IETF Announce]     [Security]     [Font Config]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux Kernel]

  Powered by Linux