Re: Xfree86 and PCI domains on psarc.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Ahh, good.  You didn't say it was broken or impossible, this gives me hope :)
For my setup I only have 0000:, can I hard code this some where?
Also I might make BusID understand the new format.

What else will needs doing once X looks at the right place in proc?
I have a good handle on Xfree86 drivers and pci buses.  What should I have read, be reading?

--- "David S. Miller" <davem@xxxxxxxxxx> wrote:
> On Tue, 30 Dec 2003 18:02:24 -0800 (PST)
> Mike Mestnik <cheako911@xxxxxxxxx> wrote:
> 
> > I have a sparc64 with a mach64 on a pci bus.  The format of /proc/bus/pci/ has changed in 2.6
> to
> > include a pci domain!@P
> > 
> > I have not been able to locate a patch and even debian's experimental branch /w (4.3.0-0pre1v3
> > 20030929061855) dose not have support.  I'm currently building DRI-XV drivers as in
> > http://www.geekounet.org/powerbook/driplusxv.html and hoping that the DRI CVS has support.
> > 
> > I was wondering if any one knew how to fix this?
> 
> Nobody has done the work, I started on it but I have no intention
> of going back to it any time soon.

__________________________________
Do you Yahoo!?
Find out what made the Top Yahoo! Searches of 2003
http://search.yahoo.com/top2003
_______________________________________________
XFree86 mailing list
XFree86@xxxxxxxxxxx
http://XFree86.Org/mailman/listinfo/xfree86

[Index of Archives]     [X Forum]     [Xorg]     [XFree86 Newbie]     [IETF Announce]     [Security]     [Font Config]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux Kernel]

  Powered by Linux