Re: Bah! How do I change channels?

[Devin Heitmueller <dheitmueller@xxxxxxxxxxxxxx>]

On Fri, Jun 26, 2009 at 1:19 PM, Robert
Krakora<rob.krakora@xxxxxxxxxxxxxxxxxxxxx> wrote:
> I had ran into this before with the KWorld a few months back.
> However, whatever problem existed that forced me to add
> "no_poweroff=1" to modprobe.conf for the em28xx module has went away.
> I have been able to use v4l-ctl or ivtv-tune without any problems to
> tune analog channels over cable.

Well, bear in mind that if you run v4l-ctl *after* the program is
streaming it should work.  However, if you run v4l-ctl and then try to
stream I suspect it will fail.

If it's working, then perhaps I should take a look at the power
management code in em28xx/xc2028 since I don't know why it would work
(and perhaps the tuner is *not* being powered down like it should be).

Devin

-- 
Devin J. Heitmueller - Kernel Labs
http://www.kernellabs.com

--
video4linux-list mailing list
Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list