Re: support for Hauppauge WinTV PCI-FM model 747?

[Graham Lee Bevan <graham.bevan@xxxxxxxxxxxx>]

Veiko,
	If this is the same card as mine (subsystem 0070:3401), then the tuner
is "TCL MFPE05 2", which maps to tuner type=38 "Philips PAL/SECAM multi
(FM1216ME MK3)".

	There is a patch to tveeprom.c in cvs to fix this, which I believe has
only recently been submitted for inclusion in 2.6.13 linux kernel.  I
would suggest you install the latest v4l from cvs.

glbevan


Veiko Kukk wrote:
> Hi!
> 
> I recently bought this TV card and need to get it working under linux.
> Pictures of the card are at the address: http://www.linux.ee/~veiko/hauppauge
> 
> Currently using Gentoo with the latest 2.6.13-rc4 kernel and todays cvs version
> of video4linux.
> As can be seen on pictures, this card has Conexant cx23881-19 chip and LG
> TAPE-S001D tuner.
> 
> I chose card=1 (Hauppauge WinTV 34xxx models) from CARDLIST.cx88 and tuner=55
> (LG PAL (TAPE series)) from CARDLIST.tuner.
> 
> 'modprobe cx88xx card=1 tuner=55'
> 'modprobe cx8800'
> 
> dmesg output:
> 
> Linux video capture interface: v1.00
> cx2388x v4l2 driver version 0.0.5 loaded
> ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
> ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [APC1] -> GSI 16 (level, high) ->
> IRQ 21
> cx88[0]: subsystem: 0070:3401, board: Hauppauge WinTV 34xxx models
> [card=1,insmod option]
> TV tuner 55 at 0x1fe, Radio tuner -1 at 0x1fe
> tveeprom: Hauppauge: model = 34519, rev = J160, serial# = 2960922
> tveeprom: tuner = LG S001D MK3 (idx = 60, type = 4)
> tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17)
> tveeprom: audio_processor = MSP3425 (type = 15)
> cx88[0]: registered IR remote control
> cx88[0]/0: found at 0000:01:08.0, rev: 5, irq: 21, latency: 32, mmio: 0xe7000000
> tda9885/6/7: chip found @ 0x86
> cx88[0]/0: registered device video0 [v4l2]
> cx88[0]/0: registered device vbi0
> cx88[0]/0: registered device radio0
> 
> Tried with kdetv, tvtime and xawtv with no luck at all. Only colorful video
> noise from tuner. Havent even think about radio yet.
> 
> Is it possible that support for that card is implemented soon in video4linux or
> should i give up?
> 
> --
> Veiko
> 
> --
> 
> Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/video4linux-list
> 

--

Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list