PAL-I tuner defaults to PAL-BG

[Andrew Wilkinson <andrewjwilkinson@xxxxxxxxx>]

Hi,

I have a cx8800 based card that works fine, I have sound and picture
apart from the fact that it defaults to PAL-BG. I live in the UK so I
need PAL-I to get proper sound, but when an application sets the tv
norm to PAL the card goes into PAL-BG mode and I need to use v4lctl to
set it to PAL-I.

Is there anyway to force the tuner to PAL-I mode? From the way it is
detected (given below) it looks like it is recognised as a PAL-I
tuner, I also have 'options tuner pal=i' in my /etc/modules.conf.

Can anyone help me?

Cheers,
Andrew Wilkinson

Mar 12 22:10:28 andrew Linux video capture interface: v1.00
Mar 12 22:10:28 andrew cx2388x v4l2 driver version 0.0.4 loaded
Mar 12 22:10:28 andrew cx2388x: snapshot date 2005-03-10
Mar 12 22:10:28 andrew ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 16
(level, low) -> IRQ 193
Mar 12 22:10:28 andrew cx88[0]: subsystem: 0070:3401, board: Hauppauge
WinTV 34xxx models [card=1,autodetected]
Mar 12 22:10:28 andrew tuner 0-0061: chip found @ 0xc2 (cx88[0])
Mar 12 22:10:28 andrew tveeprom: Hauppauge: model = 34705, rev = E111,
serial# = 6618563
Mar 12 22:10:28 andrew tveeprom: tuner = Philips FI1246 MK2 (idx = 11, type = 1)
Mar 12 22:10:28 andrew tveeprom: tuner fmt = PAL(I) (eeprom = 0x10,
v4l2 = 0x00000010)
Mar 12 22:10:28 andrew tveeprom: audio_processor = MSP3425 (type = 15)
Mar 12 22:10:28 andrew cx88[0]: registered IR remote control
Mar 12 22:10:28 andrew cx88[0]/0: found at 0000:00:09.0, rev: 3, irq:
193, latency: 64, mmio: 0xf8000000
Mar 12 22:10:28 andrew tuner 0-0061: type set to 1 (Philips PAL_I
(FI1246 and compatibles))
Mar 12 22:10:28 andrew cx88[0]/0: registered device video0 [v4l2]
Mar 12 22:10:28 andrew cx88[0]/0: registered device vbi0
Mar 12 22:10:28 andrew cx88[0]/0: registered device radio0

--

Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list