Re: Problems with a WIntv Go Card

[Ian Pickworth <ian@xxxxxxxxxxxxxxx>]

Neil Townsend wrote:
> Hi all,
>
> Now I enabled the cx88 module in my kernel 2.6.10. Hotplug seemed to 
> detect the card perfectly without any module options as you can see:
>
> Mar 11 20:51:34 desktop Linux video capture interface: v1.00
> Mar 11 20:51:35 desktop cx2388x v4l2 driver version 0.0.4 loaded
> Mar 11 20:51:35 desktop ACPI: PCI interrupt 0000:00:08.0[A] -> GSI 18 
> (level, low) -> IRQ 18
> Mar 11 20:51:35 desktop cx88[0]: subsystem: 0070:3401, board: Hauppauge 
> WinTV 34xxx models [card=1,autodetected]
> Mar 11 20:51:35 desktop cx88[0]: hauppauge eeprom: model=34705, 
> tuner=Temic 4066FY5 (18), radio=no
> Mar 11 20:51:35 desktop cx88[0]/0: found at 0000:00:08.0, rev: 3, irq: 
> 18, latency: 32, mmio: 0xdd000000
> Mar 11 20:51:35 desktop tuner: chip found at addr 0xc2 i2c-bus cx88[0]
> Mar 11 20:51:35 desktop tuner: type set to 18 (Temic PAL_I (4066 FY5)) 
> by cx88[0]

Based on the output above I would suggest getting the latest snapshot 
from http://linux.bytesex.org/, build it according to instructions on 
the site, make sure duplicate modules are removed (a previous post of 
mine had a script for this), and trying again.
Regards
Ian

--

Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list