B&W only with cx8800 | |
| [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] | |
I have a hauppauge wintv PCI-FM model 747 and I'm running with a 2.6.10 kernel w/ the latest patches of the driver from http://linux.bytesex.org/v4l2/. (using tvtime as a viewer) With the tda9887 I can tune in to some stations (w/o I can't). However, all the stations are black and white only, and not entirely sharp... finetuning it doesn't improve it. doing modprobe cx8800 tuner=14 gives an error: cx8800: Unknown parameter `tuner' This is the output of dmesg Linux video capture interface: v1.00 cx2388x v4l2 driver version 0.0.4 loaded ACPI: PCI interrupt 0000:04:01.0[A] -> GSI 17 (level, low) -> IRQ 17 cx88[0]: subsystem: 0070:3401, board: Hauppauge WinTV 34xxx models [card=1,autodetected] tuner: chip found at addr 0xc2 i2c-bus cx88[0] tda9885/6/7: chip found @ 0x86 tveeprom: Hauppauge: model = 34519, rev = J157, serial# = 2848059 tveeprom: tuner = Philips FM1216 ME MK3 (idx = 57, type = 38) tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) tveeprom: audio_processor = MSP3425 (type = 15) cx88[0]: registered IR remote control cx88[0]/0: found at 0000:04:01.0, rev: 5, irq: 17, latency: 64, mmio: 0xdd000000 tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by cx88[0] cx88[0]/0: registered device video0 [v4l2] cx88[0]/0: registered device vbi0 cx88[0]/0: registered device radio0 cx88[0]/0: set_audio_standard_BTSC (status: known-good) cx88[0]/0: cx88: tvaudio thread started cx88[0]/0: AUD_STATUS: 0xffe2 [mono/no pilot] ctl=BTSC_AUTO_STEREO cx88[0]/0: AUD_STATUS: 0xfb32 [mono/no pilot] ctl=BTSC_AUTO_STEREO cx88[0]/0: AUD_STATUS: 0xfaf2 [mono/no pilot] ctl=BTSC_AUTO_STEREO cx88[0]/0: AUD_STATUS: 0xfbb2 [mono/no pilot] ctl=BTSC_AUTO_STEREO Does anyone have any thoughts on this? -- Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/video4linux-list
|
