cx88 based card and IR Remote | |
| [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] | |
Hi,
I just read in the changelog for the cx88 driver that IR support is now
available. My question is, how do I activate/use this? I have a Leadtek
WinFast TV2000 XP card. Here is some information about the card,
lspci -vv output:
0000:02:07.0 Multimedia video controller: Conexant Winfast TV2000 XP (rev 05)
Subsystem: LeadTek Research Inc.: Unknown device 6613
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (5000ns min, 13750ns max), cache line size 08
Interrupt: pin A routed to IRQ 19
Region 0: Memory at fa000000 (32-bit, non-prefetchable)
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
my current lsmod output:
Module Size Used by
tda9887 11928 0
tuner 19752 0
cx8800 26128 0
cx88xx 46112 1 cx8800
video_buf 16772 2 cx8800,cx88xx
ir_common 4100 1 cx88xx
v4l1_compat 13060 0
v4l2_common 4864 0
btcx_risc 3848 2 cx8800,cx88xx
and my dmesg output:
cx2388x v4l2 driver version 0.0.4 loaded
cx2388x: snapshot date 2004-11-30
ACPI: PCI interrupt 0000:02:07.0[A] -> GSI 19 (level, low) -> IRQ 19
cx88[0]: subsystem: 107d:6613, board: Leadtek Winfast 2000XP Expert
[card=5,autodetected]
cx88[0]: Leadtek Winfast 2000 XP config: tuner=43, eeprom[0]=0x01
cx88[0]/0: found at 0000:02:07.0, rev: 5, irq: 19, latency: 32, mmio:
0xfa000000
tuner: chip found at addr 0xc0 i2c-bus cx88[0]
tuner: type set to 43 (Philips NTSC MK3 (FM1236MK3 or FM1236/F)) by cx88[0]
tda9885/6/7: chip found @ 0x86
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/0: registered device radio0
There is nothing about the IR part though... and there is also no entry
in /proc/bus/input/devices.
How can I get the IR remote working? I would really appreciate your input.
Regards,
Manuel
--
Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list
|
