Diseqc problems with VDR1.7.19

["Hawes, Mark" <MARK.HAWES@xxxxxxxxxxxxxx>]

Hi,

 

Since upgrading to VDR 1.7.19 I have experienced problems with Diseqc.

 

My diseqc configuration uses command strings which contain 3 code sets: a diseqc switch command, a diseqc go to command, and a repeat goto command.

 

Since upgrading to VDR 1.7.19 it appears that the only code set sent is the last one, but it’s sent three times.

 

To demonstrate this I have put some trace in cDvbTuner::SetFrontend within dvbdevice.c which traces the complete diseqc string, the diseqc action, and for diseqc codes – the actual diseqc code sent. It produces the following output:

 

Diseqc command list found = t v [E0 10 38 F4] W500 [E0 31 6B 04] W250 [E0 31 6B 04] W15 T

Diseqc action = "">

Diseqc action = "">

Diseqc action = "">

Sending Diseqc command: E0 31 6B 04 < Wrong, should be E0 10 38 F4 >

Diseqc action = "">

Sending Diseqc command: E0 31 6B 04 < Wrong, should be E0 31 6B 04 >

Diseqc action = "">

Sending Diseqc command: E0 31 6B 04

Diseqc action = "">

 

The same trace in vdr 1.7.18 shows the correct codes being sent in the correct sequence.

 

I note that some work was done in this area for 1.7.19 but my C++ skills are a little weak to diagnose the problem any further.

 

Can anybody throw some more light on what’s going on?

 

Thanks,

 

Mark.

 

 

 

 

 

 

Mark Hawes
Senior Project Manager

Fujitsu Australia Limited
825 Bourke Street, Docklands VIC 3008, Australia
T +61 3 9924 3240 M +61 416 140 218 F +61 3 9924 3001
mark.hawes@xxxxxxxxxxxxxx
au.fujitsu.com

 

_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr