device not accepting address

[John Leidel <john.leidel@xxxxxxxxx>]

All, I've run into a bit of trouble in trying to get my Treo 650 to
register with the usb driver.  So... the process is as follows.  I load
the `visor` module [which also loads `usbserial`].  I try a hotsync
operation.  A new device should appear as /dev/ttyUSB1 or /dev/ttyUSB0
aliased to /dev/pilot.  No devices appear.  The syslog and dmesg report
the following: 

Nov 24 20:42:34 e521 kernel: usb 1-5: new full speed USB device using
ohci_hcd and address 23
Nov 24 20:42:35 e521 kernel: usb 1-5: device descriptor read/64, error
-110
Nov 24 20:42:35 e521 kernel: usb 1-5: device descriptor read/64, error
-110
Nov 24 20:42:35 e521 kernel: usb 1-5: new full speed USB device using
ohci_hcd and address 24
Nov 24 20:42:35 e521 kernel: usb 1-5: device descriptor read/64, error
-110
Nov 24 20:42:35 e521 kernel: usb 1-5: device descriptor read/64, error
-110
Nov 24 20:42:36 e521 kernel: usb 1-5: new full speed USB device using
ohci_hcd and address 25
Nov 24 20:42:36 e521 kernel: usb 1-5: device not accepting address 25,
error -110
Nov 24 20:42:36 e521 kernel: usb 1-5: new full speed USB device using
ohci_hcd and address 26
Nov 24 20:42:37 e521 kernel: usb 1-5: device not accepting address 26,
error -110

I've tried all the notes listed on the linux-usb.org FAQ page.  None
seem to work.  Anyone have any other suggestions?? 

I'm running opensuse 10.1 x86_64 2.6.16.13-4-smp on a dell e521 open
source desktop.  

thanks
john 


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Linux-usb-users@xxxxxxxxxxxxxxxxxxxxx
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users