RE: Using the 'at' command
|[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]|
I read, and re-read, the man pages, and searched online but couldn't find an example of what I was trying to do. I know that I can always submit a question to this list and get an answer.
Here is what actually worked:
#at -f /tmp/tmp$$.sh $eventTime $eventDate-$minBefore min
The at command didn't like any spaces before the "-$minBefore".
Thanks for your reply, Cameron.
From: Cameron Simpson [mailto:cs@xxxxxxxxxx]
Sent: Friday, November 07, 2003 11:31 PM
Subject: Re: Using the 'at' command
On 11:33 06 Nov 2003, Quillen, Channon <CQuillen@xxxxxxxxxxxx> wrote:
| I have been successful in running the 'at' command at a later time and date,
| however I would like to also like to be able to specify a certain number of
| minutes less.
| For example,
| This command will work: at -f /tmp/tmp1735.sh 11:27 11/06/03
| This command will not: at -f /tmp/tmp1735.sh 11:27-2 min 11/06/03
at -f /tmp/tmp1735.sh 11:27 11/06/03 -2min
i.e. don't drop it in the middle of the date. These things have
a sequence. Full syntax is in the file /usr/share/doc/at-3.1.8/timespec
(you may have to adjust for your version of at - the manual entry has
the appropriate string). It's clear from the syntax that you can both
add and subtract time _at_the_end_ of the spec. Snippet:
timespec : spec_base
| spec_base inc_or_dec
And off it goes. Very readable.
Cameron Simpson <cs@xxxxxxxxxx> DoD#743
With no clue of the technique, how can one hope to master the maneuver?
- Ed Green
Psyche-list mailing list
[Fedora General Discussion] [Red Hat General Discussion] [Centos] [Kernel] [Red Hat Install] [Red Hat Watch] [Red Hat Development] [Red Hat 9] [Gimp] [Yosemite News]