| [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] |
Hi there, Well I checked out the driver but there is no jumper setting available on the disk, like the case in IDE. It just have :- 1. Power Connector 2. 2 FireWire Ports Apart from this there is nothing outside the drive. Regards, Rishabh -----Original Message----- From: Dan Hollis [mailto:goemon@xxxxxxxxx] Sent: Monday, August 18, 2003 11:27 PM To: Rishabh Kumar Goel Cc: redhat-devel-list@xxxxxxxxxx Subject: Re: FireWire HDD problem On Mon, 18 Aug 2003, Rishabh Kumar Goel wrote: > I have a Bencent 3.5" FireWire HDD. I also have a TI's TSB43ab22 iOHCI PCI > card with a PCI-PCI bridge interface. You have to set the drive for cable select, not master or slave. -Dan -- [-] Omae no subete no kichi wa ore no mono da. [-] Scanned by SecureSynergy VirusScreen Service. For more information log on to : http://www.securesynergyonline.com or http://www.securesynergy.com _______________________________________________ Redhat-devel-list mailing list Redhat-devel-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/redhat-devel-list