Can not start md0 after upgrade.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Just upgraded a poweredge 1850 server from Debian lenny to squeeze and can not 
boot with the new 2.6.32 kernel.

>From lspci  have this controller:
SCSI storage controller: LSI Logic / Symbios Logic 53c1030 PCI-X Fusion-MPT 
Dual Ultra320 SCSI (rev 08)


Running mdadm raid with root on md0.

Normally run xen but all  info is for when running without xen.

I can still boot with the 2.6.26 kernel but not with the new 2.6.32 kernel.
Under 2.6.32 it fails to start md0.
in the busy box console 
Can see all the needed partitions.
What was sda and sdb are now sdb and sdc that should not matter??
mdadm.conf is:
DEVICE partitions
CREATE owner=root group=disk mode=0660 auto=yes
HOMEHOST <system>
MAILADDR xxxxx@xxxxxxxxxxx
ARRAY /dev/md0 level=raid1 num-devices=2 
UUID=6f744c89:d2578f95:c150b018:d9f789b1
ARRAY /dev/md1 level=raid1 num-devices=2 
UUID=7938d59c:28a69e5e:3facbdc2:12974557

raid1 mptbase mptscsih and mptspi module are loaded.
Looks right but does not start md0.

Any ideas?

Thanks

John
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux RAID Wiki]     [ATA RAID]     [Linux SCSI Target Infrastructure]     [Linux Block]     [Linux IDE]     [Linux SCSI]     [Linux Hams]     [Device Mapper]     [Device Mapper Cryptographics]     [Kernel]     [Linux Admin]     [Linux Net]     [GFS]     [RPM]     [git]     [Yosemite Forum]


  Powered by Linux