under Synopsis: ethtool --get-eee devname ethtool --set-eee devname [eee on|off] [tx-lpi on|off] [tx-timer N] [advertise N] under Options: --get-eee Queries the specified network device for its support in Efficient Energy Ethernet (ac- cording to the IEEE 802.3az specifications) --set-eee Sets the device EEE behaviour. eee on|off Enables/Disables the device support in EEE. tx-lpi on|off Determines whether the device should assert its tx lpi. advertise N Sets the speeds for which the device would advertise EEE capabliities. Values are as for --change advertise tx-timer N Sets the amount of time the device should stay in idle mode prior to asserting its tx lpi (in microseconds). This has meaning only when tx lpi is on. Signed-off-by: Yuval Mintz <yuvalmin@xxxxxxxxxxxx> Signed-off-by: Eilon Greenstein <eilong@xxxxxxxxxxxx> --- ethtool.8.in | 32 ++++++++++++++++++++++++++++++++ 1 files changed, 32 insertions(+), 0 deletions(-) diff --git a/ethtool.8.in b/ethtool.8.in index 523b737..b906d8e 100644 --- a/ethtool.8.in +++ b/ethtool.8.in @@ -335,6 +335,16 @@ ethtool \- query or control network driver and hardware settings .I devname flag .A1 on off .RB ... +.HP +.B ethtool \-\-get\-eee +.I devname +.HP +.B ethtool \-\-set\-eee +.I devname +.B2 eee on off +.B2 tx-lpi on off +.BN tx-timer +.BN advertise . .\" Adjust lines (i.e. full justification) and hyphenate. .ad @@ -817,6 +827,28 @@ Sets the device's private flags as specified. .I flag .A1 on off Sets the state of the named private flag. +.TP +.B \-\-get\-eee +Queries the specified network device for its support in Efficient Energy +Ethernet (according to the IEEE 802.3az specifications) +.TP +.B \-\-set\-eee +Sets the device EEE behaviour. +.TP +.A2 eee on off +Enables/Disables the device support in EEE. +.TP +.A2 tx-lpi on off +Determines whether the device should assert its tx lpi. +.TP +.BI advertise \ N +Sets the speeds for which the device would advertise EEE capabliities. +Values are as for +.B \-\-change advertise +.TP +.BI tx-timer \ N +Sets the amount of time the device should stay in idle mode prior to asserting +its tx lpi (in microseconds). This has meaning only when tx lpi is on. .SH BUGS Not supported (in part or whole) on all network drivers. .SH AUTHOR -- 1.7.9.rc2 -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html