Re: [PATCH 0/7] Prerequisites for BCM63XX UDC driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 23/06/12 07:14, Kevin Cernekee wrote:
> These patches are intended to lay the groundwork for a new USB Device
> Controller (gadget UDC) driver.  arch/mips/bcm63xx updates include:
> 
> Clock enable bits
> DMA descriptor updates
> New register and IRQ definitions
> Create platform_device and platform_data
> 
> Baseline is:
> 
> git://git.linux-mips.org/pub/scm/ralf/upstream-sfr.git #mips-for-linux-next
> 
> Note that this is not an OTG-capable controller.  Therefore, boards are
> permanently wired up for either host mode or device mode.  Device vs.
> host can be determined in board_bcm963xx.c based on the detected board ID.
> Some boards have connectors/pads for both modes, but need to be
> reworked to run in device mode; usually this involves moving 0-ohm
> resistors on the D+ and D- lines.


Thanks, queued the whole series for 3.7

	John





[Index of Archives]     [Linux MIPS Home]     [LKML Archive]     [Linux ARM Kernel]     [Linux ARM]     [Linux]     [Git]     [Yosemite News]     [Linux SCSI]     [Linux Hams]

  Powered by Linux