Re: [PATCH V1] fix adc to voltage calculation in da9052 power driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



> -----Original Message-----
> From: Guenter Roeck [mailto:groeck7@xxxxxxxxx] On Behalf Of Guenter
> Roeck
> Sent: 19 December 2013 18:11
> To: Jean Delvare
> Cc: Opensource [Anthony Olech]; lm-sensors@xxxxxxxxxxxxxx; Anton
> Vorontsov; David Woodhouse; linux-kernel@xxxxxxxxxxxxxxx; David Dajun
> Chen
> Subject: Re:  [PATCH V1] fix adc to voltage calculation in da9052
> power driver
> On Thu, Dec 19, 2013 at 03:54:54PM +0100, Jean Delvare wrote:
> > Hi Anthony,
> >
> [ ... ]
> > BTW, you (and we) probably shouldn't waste too much energy on this.
> > ADCs are only accurate to some degree anyway. If you take the
> > components connected to the input into consideration, the accuracy
> > gets even worse. For example, if the input voltage must be scaled down
> > to fit in the ADC's range, you need at least one resistor, which in
> > best cases will have a 1% accurate value (known as tolerance.) That's
> > ten times the LSB of your 10-bit ADC, at which point / 1023 or / 1024
> > really makes no practical difference. Sub-percent tolerant resistors
> > are expensive and rare in consumer electronics in my experience.
> True, but on the other side (and after looking into the datasheet) the driver
> already calculated the voltage on adc4..6 correctly, so unless you disagree I
> would like to apply the hwmon patch to -next for consistency.
> Thanks,
> Guenter

OK, thanks,
Tony Olech

_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors




[Index of Archives]     [Linux Kernel]     [Linux Hardware Monitoring]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux