Re: RTL8187 rate control problems

["John W. Linville" <linville@xxxxxxxxxxxxx>]

On Tue, Nov 06, 2007 at 01:23:16PM -0200, Claudio Matsuoka wrote:

> I've been reported a problem with RTL8187 working only at very close ranges 
> (4-5m) in Linux while the same hardware works at much higher distances in 
> Windows. Investigating the problem, I found that it's caused by the mac80211 
> rate control incrementing the bit rate to 54M and never going down because 
> the fail counter stays at zero. What would be a good way to check 
> transmission retries or failures in the RTL8187 to prevent this problem? Is 
> it possible to have a retry count sent to the tx callback so 
> status->retry_count could be set accordingly?   

I think you are right -- it looks like rtl8187 never sets
excessive_retries for transmit status.  I don't see anything obvious
in the specs that would give us an actual indication of that either,
which probably explains why it is missing.

The zd1211rw(-mac80211) driver(s) have a mechanism for matching-up
received ACKs with transmitted frames so that they can synthesize the
required excessive_retries data.  Probably rtl8186 needs something
similar.  Maybe this would even be worth generalizing?

John
-- 
John W. Linville
linville@xxxxxxxxxxxxx
-
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html