[patch] watchdog: sch56xx-common: set correct bits in register()

[Dan Carpenter <dan.carpenter@xxxxxxxxxx>]

WDOG_NO_WAY_OUT (3) and WDOG_ACTIVE (0) are the bit numbers, not a mask.
So "data->wddev.status |= WDOG_ACTIVE;" was intended to set bit zero but
it is a no-op.

Signed-off-by: Dan Carpenter <dan.carpenter@xxxxxxxxxx>

diff --git a/drivers/hwmon/sch56xx-common.c b/drivers/hwmon/sch56xx-common.c
index 839087c..4380f5d 100644
--- a/drivers/hwmon/sch56xx-common.c
+++ b/drivers/hwmon/sch56xx-common.c
@@ -464,9 +464,9 @@ struct sch56xx_watchdog_data *sch56xx_watchdog_register(struct device *parent,
 	data->wddev.min_timeout = 1;
 	data->wddev.max_timeout = 255 * 60;
 	if (nowayout)
-		data->wddev.status |= WDOG_NO_WAY_OUT;
+		set_bit(WDOG_NO_WAY_OUT, &data->wddev.status);
 	if (output_enable & SCH56XX_WDOG_OUTPUT_ENABLE)
-		data->wddev.status |= WDOG_ACTIVE;
+		set_bit(WDOG_ACTIVE, &data->wddev.status);
 
 	/* Since the watchdog uses a downcounter there is no register to read
 	   the BIOS set timeout from (if any was set at all) ->
--
To unsubscribe from this list: send the line "unsubscribe kernel-janitors" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html