Re: [PATCH] libata-zpodd: must use ata_tf_init()

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 06/26/2013 07:10 PM, Sergei Shtylyov wrote:
> Hello.
> 
> On 26-06-2013 6:05, Aaron Lu wrote:
> 
>>> There are  some SATA controllers which have both devices 0 and 1 but this module
> 
>> Do you mean a SATA port can connect to two SATA devices without PMP?
> 
>     No, I mean 2 SATA ports combined in one ATA channel as 2 devices. 
> Look for SLAVE_POSS in drivers/ata/[s]ata*.c...

Oh yes that happened when the SATA controller is in IDE programming
mode, not AHCI.

ZPODD is only supported for SATA controllers in AHCI programming mode,
the ACPI table will not support power off the port if the controller is
in IDE mode, so the device 1 case shouldn't happen in practice :-)

Thanks,
Aaron
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux