[PATCH] pata_sis: enable MWDMA for UDMA 133 chipset

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



This ports the timing values over from the old IDE driver into the new
PATA-based one. The comment was lying when it stated the old driver was
not MWDMA capable.

Boot tested on actual hardware using 'libata.force=mwdma2'.

Signed-off-by: Dan McGee <dpmcgee@xxxxxxxxx>
---
 drivers/ata/pata_sis.c |   27 +++++++++++++++++----------
 1 files changed, 17 insertions(+), 10 deletions(-)

diff --git a/drivers/ata/pata_sis.c b/drivers/ata/pata_sis.c
index 810b7d6..9f11a8e 100644
--- a/drivers/ata/pata_sis.c
+++ b/drivers/ata/pata_sis.c
@@ -293,14 +293,14 @@ static void sis_133_set_piomode (struct ata_port *ap, struct ata_device *adev)
 	u32 t1;
 	int speed = adev->pio_mode - XFER_PIO_0;
 
-	const u32 timing133[] = {
+	static const u32 timing133[] = {
 		0x28269000,	/* Recovery << 24 | Act << 16 | Ini << 12 */
 		0x0C266000,
 		0x04263000,
 		0x0C0A3000,
 		0x05093000
 	};
-	const u32 timing100[] = {
+	static const u32 timing100[] = {
 		0x1E1C6000,	/* Recovery << 24 | Act << 16 | Ini << 12 */
 		0x091C4000,
 		0x031C2000,
@@ -485,21 +485,28 @@ static void sis_133_set_dmamode (struct ata_port *ap, struct ata_device *adev)
 	int port;
 	u32 t1;
 
-	/* bits 4- cycle time 8 - cvs time */
-	static const u32 timing_u100[] = { 0x6B0, 0x470, 0x350, 0x140, 0x120, 0x110, 0x000 };
-	static const u32 timing_u133[] = { 0x9F0, 0x6A0, 0x470, 0x250, 0x230, 0x220, 0x210 };
-
 	port = sis_port_base(adev);
 	pci_read_config_dword(pdev, port, &t1);
 
 	if (adev->dma_mode < XFER_UDMA_0) {
+		/* Recovery << 24 | Act << 16 | Ini << 12, like PIO modes */
+		static const u32 timing_u100[] = { 0x19154000, 0x06072000, 0x04062000 };
+		static const u32 timing_u133[] = { 0x221C6000, 0x0C0A3000, 0x05093000 };
+		int speed = adev->dma_mode - XFER_MW_DMA_0;
+		t1 &= 0xC0C00FFF;
+		/* disable UDMA */
 		t1 &= ~0x00000004;
-		/* FIXME: need data sheet to add MWDMA here. Also lacking on
-		   ide/pci driver */
+		if (t1 & 0x08)
+			t1 |= timing_u133[speed];
+		else
+			t1 |= timing_u100[speed];
 	} else {
+		/* bits 4- cycle time 8 - cvs time */
+		static const u32 timing_u100[] = { 0x6B0, 0x470, 0x350, 0x140, 0x120, 0x110, 0x000 };
+		static const u32 timing_u133[] = { 0x9F0, 0x6A0, 0x470, 0x250, 0x230, 0x220, 0x210 };
 		int speed = adev->dma_mode - XFER_UDMA_0;
-		/* if & 8 no UDMA133 - need info for ... */
 		t1 &= ~0x00000FF0;
+		/* enable UDMA */
 		t1 |= 0x00000004;
 		if (t1 & 0x08)
 			t1 |= timing_u133[speed];
@@ -620,7 +627,7 @@ static const struct ata_port_info sis_info100_early = {
 static const struct ata_port_info sis_info133 = {
 	.flags		= ATA_FLAG_SLAVE_POSS,
 	.pio_mask	= ATA_PIO4,
-	/* No MWDMA */
+	.mwdma_mask	= ATA_MWDMA2,
 	.udma_mask	= ATA_UDMA6,
 	.port_ops	= &sis_133_ops,
 };
-- 
1.7.6.1

--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux