Re: [PATCH v2 7/8] ARM: LPC32xx: DTS files for device tree conversion

[Arnd Bergmann <arnd@xxxxxxxx>]

On Tuesday 17 April 2012, Roland Stigge wrote:
> +	ahb {
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		compatible = "simple-bus";
> +		ranges = <0x20000000 0x20000000 0x30000000>;
> +
> +		slc: flash@20020000 {
> +			compatible = "nxp,nand-slc";
> +			reg = <0x20020000 0x1000>;
> +			status = "disable";
> +		};
> +
> +		mlc: flash@200B0000 {
> +			compatible = "nxp,nand-mlc";
> +			reg = <0x200B0000 0x1000>;
> +			status = "disable";
> +		};

You have the flash chips in here, which seem right, but I would expect
to see the phy3250 file pick this up again and define partitions in
it, at least if there is a well-defined partition layout for that
board.

> +
> +	chosen {
> +		bootargs = "console=ttyS0,115200n81 root=/dev/ram0";
> +	};

I think in general it's better not to list a command line like this,
it should instead get set by the boot loader or using ARM_ATAG_DTB_COMPAT.

	Arnd
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel