Re: Too many xruns
|[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]|
On 09/05/2012 09:24 PM, Kevin Cosgrove wrote:
Xrunning system says: 0 [PCH ]: HDA-Intel - HDA Intel PCH HDA Intel PCH at 0xf7e20000 irq 70 1 [M1010 ]: ICE1712 - M Audio Delta 1010 M Audio Delta 1010 at 0xa040, irq 16 2 [NVidia ]: HDA-Intel - HDA NVidia HDA NVidia at 0xf7080000 irq 17 Fine system says: 0 [Intel ]: HDA-Intel - HDA Intel HDA Intel at 0xfbff8000 irq 30 1 [M1010 ]: ICE1712 - M Audio Delta 1010 M Audio Delta 1010 at 0xec00, irq 17 I'm using the Delta 1010 cards on each system with Jack & Ardour.
Hello Kevin, thanks for the results!Ok, that looks good, so it's about a Delta 1010 card which uses the snd_ice1712 kernel module.
cat /proc/interrupts16: 56322 0 0 0 0 0 0 0 IO-APIC-fasteoi ahci, ehci_hcd:usb1, firewire_ohci, snd_ice1712, nvidia
There you go, looks kinda busy there. Looks a bit like the situation on my notebook:
16: 320312 30 IO-APIC-fasteoi uhci_hcd:usb3, mmc0, firewire_ohci, jmb38x_ms:slot0, eth1, nvidia
But I manage to use to run a FireWire audio card just fine on this notebook so there's still hope for your Delta 1010 ;)
Fine system says: 17: 0 0 0 0 IO-APIC-fasteoi ICE1712
Here it's sitting on it's own interrupt so it'll probably run fine
cat /sys/devices/system/cpu/cpu*/cpufreq/scaling_governorXrunning system says: ondemand ondemand ondemand ondemand ondemand ondemand ondemand ondemand
Nice, 4 cores and hyperthreading? Or really 8 cores? But the ondemand governor might be a culprit (I say *might*, I'm still not 100% sure in how far the ondemand scaling governor affects JACK's performance).
More information on tweaking your setup: http://wiki.linuxmusicians.com/doku.php?id=system_configurationExcellent resource. I was also going to try installing the CCRMA RT kernel and any "accessories" it might require.
Then also install rtirq (or rtirq-init) and check the section in the Wiki on rtirq. Make sure you put snd_ice1712 in the list of softirqs that need to get prio. Put it first or second in the list. This will free it from the burden of having to share its hardware interrupt with all the other stuff. You could also try moving the Delta 1010 to another slot, if possible a slot with a free IRQ. that would be the best option.
Thanks much! -- Kevin _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
_______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user