Re: is my modem listed/supported

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Joe,

scanModem will try to list/recommend a driver(s) for your modems.

http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php

You may download the generic download package:

http://www.linuxant.com/drivers/hsf/full/archive/hsfmodem-7.80.02.06full/hsfmodem_7.80.02.06full_i386.deb.zip

Install with:

METHOD B: DEBIAN PACKAGE (*.deb)
If you have obtained the driver package in DEBIAN format:

1. install the package with "dpkg -i hsfmodem_{version}_{arch}.deb",
if apt-get or some other tool hasn't already done it for you.

2. if necessary, run "hsfconfig" to complete the installation, enter
license information, or to change your modem's configuration.

If you need to rebuild the Debian generic package from source, you can
get the TAR package, and from the top directory run: "make debdist". A
pre-compiled DEB package for the currently running kernel can be built
using "make debprecomp" instead.

as provided instructions here:

http://www.linuxant.com/drivers/hsf/install.php

> Also are there going to be drivers for Kodak 5250 drivers for the
> scanner portion. I have the printer working not the scanner.

I do not know the answer to this specific question, but I recommend
that you take a look to see if simple scan/sane can recognize the
scanner.  But this question is outside the realm of what we are here
to help for.

Regards,

Antonio


On Tue, Aug 16, 2011 at 7:03 PM, Joe (From The Cape) Reynolds
<joefromthecape@xxxxxxxxx> wrote:
> Where can I get drivers?
> Which drivers ?
>
> Also are there going to be drivers for Kodak 5250 drivers for the
> scanner portion. I have the printer working not the scanner.
>
> Thanks
>
> Joe
>
>
>
> On 08/16/2011 07:37 PM, Antonio Olivares wrote:
>> Joe,
>>
>> your modem should be supported by hsfmdoem drivers
>>
>> Predictive  diagnostics for card in bus 01:07.0:
>>       Modem chipset  detected on
>> NAME="Communication controller: Conexant Systems, Inc. Device 2f40"
>> CLASS=0780
>> PCIDEV=14f1:2f40
>> SUBSYS=14f1:2000
>> IRQ=11
>> HDA2=00:05.0
>> IDENT=hsfmodem
>> Driver=hsfmodem-drivers
>>
>>  For candidate modem in:  01:07.0
>>    0780 Communication controller: Conexant Systems, Inc. Device 2f40
>>       Primary device ID:  14f1:2f40
>>  Support type needed or chipset:      hsfmodem
>>
>>
>>
>> For owners of a Dell PCs with Conexant HSF modems, a driver source
>> package with full speed enabled is available, but requires driver
>> compiling. Read DOCs/Conexant.txt
>>
>>
>> Modem support packages from Linuxant include resources for compiling drivers.
>> If an installer package matching your kernel_version  is not provided,
>> just install a generic code package.
>>
>>  From  http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php
>>  download hsfmodem-7.80.02.05full_k2.6.38_10_generic_ubuntu_i386.deb.zip
>>  Under Linux unpack with:
>>  $ unzip hsfmodem*.zip
>>  Then install with:
>>  $ sudo dpkg -i hsfmodem*.deb
>>  Subsequently, the modem should be found with
>>  $ sudo wvdialconf /etc/wvdial.conf
>>  Edit in your personal information with:
>>  $ sudo gedit /etc/wvdial.conf
>>  and try dialing out with:
>>  $ sudo wvdial.
>>  See DOCs/Testing.txt  for details.
>>
>>  The directions following below need only be pursued, if the above
>> procedures are not adequate.
>>
>> Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to find the
>> hsfmodem package matching your System. For several Linux distros, there are
>> precompiled drivers matched to specific kernels. These have within the FileName,
>> your KernelVersion:   2.6.38_10_generic
>> They can be found through
>> http://www.linuxant.com/drivers/hsf/full/downloads.php
>> A more precise location may be given a few paragraphs below.
>> If an EXACT Match with your your KernelVersion is not found, one of the
>> "Generic packages with source" near the bottom of the page must be used.
>> Downloaded packages must be moved into the Linux partition (home folder is OK)
>> and unzipped with:
>>       unzip hsf*.zip
>> The installation command for a .deb suffic packages is, with root/adm
>> permission:
>>   sudo dpkg -i hsf*.deb
>> while for .rpm suffix it is, with:
>>   rpm -i hsf*.rpm
>>  Read DOCs/Conexant.txt
>>
>> Regards,
>>
>>
>>
>> Antonio
>>
>> On Tue, Aug 16, 2011 at 3:43 PM, Joe (From The Cape) Reynolds
>> <joefromthecape@xxxxxxxxx> wrote:
>>> I have an Emachine with a modem that come plugged into the eitehr pci or
>>> isa slot (I will be honest, I haven't looked where in the pc).
>>>
>>> I have attached my 1read.txt and ModemData.txt.
>>>
>>> is my modem listed/supported with your drivers?
>>>
>>> Joe from Cape Cod
>>>
>
>



[Index of Archives]     [Linux Media Development]     [Asterisk]     [DCCP]     [Netdev]     [X.org]     [Xfree86]     [Fedora Women]     [Linux USB]

  Powered by Linux