Re: Mehdi, Iran kernel 2.6.28-11-generic

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


Mehdi,

when dialing out you use YOUR_COUNTRY like USA, IRAN, and not specific
"YOUR COUNTRY" as you get :

bad country name `YOUR_COUNTRY', using default by code!

Maybe that was the cause of the failure ?

Regards,

Antonio

On Tue, Apr 5, 2011 at 8:36 PM, the mass <massreg@xxxxxxxxx> wrote:
> I followed the insturctions but I couldn't connect to the internet in
> Ubuntu 9.04 so I tryed the same procedure in Ubuntu 8.04.1,
> surprisingly this time I successfully connected to the internet.
>
> I'm wondering what's wrong in the newer version.(the modem is
> installed but doesn't dial)
>
>
> Here's what I did:
>
> As you said I downloaded "SLMODEMD_gcc4.3_alsa1.0.18.tar.gz" and after
> extraction I ran "sudo slmodemd -c YOUR_COUNTRY --alsa hw:0,6"
> here's the result:
>
> ______________________________________________
> SmartLink Soft Modem: version 2.9.11 Feb 25 2009 18:35:08
> bad country name `YOUR_COUNTRY', using default by code!
> symbolic link `/dev/ttySL0' -> `/dev/pts/2' created.
> modem `hw:0,6' created. TTY is `/dev/pts/2'
> Use `/dev/ttySL0' as modem device, Ctrl+C for termination.
> _______
>
>
> then I ran "sudo wvdialconf /etc/wvdial.conf"
> and here's the file:
>
> wvdial.conf
> ______________
> [Dialer Defaults]
> Init1 = ATZ
> Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
> Modem Type = Analog Modem
> Baud = 460800
> New PPPD = yes
> Modem = /dev/ttySL0
> ISDN = 0
> Phone = 9092322424
> Password = pass
> Username = user
> Carrier check = no
> Stupid Mode = yes
> #Dial Command = ATDP
> ____
>
> After that I tryed to connect: "sudo wvdial"
> and ...
>
> ________________________
> --> WvDial: Internet dialer version 1.60
> --> Cannot get information for serial port.
> --> Initializing modem.
> --> Sending: ATZ
> ATZ
> OK
> --> Sending: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
> ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
> OK
> --> Modem initialized.
> --> Sending: ATDT9092322424
> --> Waiting for carrier.
> ATDT9092322424
> --> Timed out while dialing.  Trying again.
> --> Sending: ATDT9092322424
> --> Waiting for carrier.
> --> Timed out while dialing.  Trying again.
> ___________
>
>
> Modem does not dial the number ( There is bing as it picks up the
> telephone but there is no dialing).
>
> Best regards,
> Mehdi
>
> _____________________________________________________________________
> ____________________________________
>
> On 4/5/11, Marvin Stodolsky <marvin.stodolsky@xxxxxxxxx> wrote:
>> Antonio,
>>    I'll write the following instruction into scanModem shortly
>>
>> Mehdi
>>
>> RE: SLMODEMD_gcc4.3_alsa1.0.18.tar.gz
>> Since you are using Ubuntu, it is better to use the Ubuntu package
>> providing slmodemd
>>  Download the package sl-modem-daemon.  Under Ubuntu it can be installed
>> with:
>> $ sudo dpkg -i sl*/deb
>>
>> Afterward the modem should be dectected by:
>> $ sudo wvdialconf
>>
>> If successful use
>> $ sudo gedit /etc/wvdial.conf
>> to add a line:
>> Carrier Check = no
>> and edit in your personal information.
>> Read the DOCs/Smartlink.txt for details.
>>
>> Please send further questions to the List, not me directly.
>>
>> MarvS
>>
>> On Tue, Apr 5, 2011 at 7:52 AM, Antonio Olivares
>> <olivares14031@xxxxxxxxx> wrote:
>>> Mehdi,
>>>
>>> scanModem reports that your modem is supported through SLMODEMD package:
>>>
>>> Predictive  diagnostics for card in bus 00:14.2:
>>>        Modem chipset  detected on
>>> NAME="Audio device: ATI Technologies Inc SBx00 Azalia "
>>> CLASS=0403
>>> PCIDEV=1002:4383
>>> SUBSYS=1043:1339
>>> IRQ=16
>>> HDA2=00:14.2
>>> SOFT=1002:4383.HDA
>>> HDAchipVendorID=1057
>>> CHIP=0x10573055
>>> IDENT=slmodemd
>>> SLMODEMD_DEVICE=hw:0,6
>>> Driver=snd-hda-intel
>>>
>>>  For candidate modem in:  00:14.2
>>>   0403 Audio device: ATI Technologies Inc SBx00 Azalia
>>>      Primary device ID:  1002:4383
>>>    Subsystem PCI_id  1043:1339
>>>    Softmodem codec or chipset from diagnostics: 0x10573055
>>>                               from    Archives:
>>>                        The HDA card softmodem chip is 0x10573055
>>>
>>>
>>> Support type needed or chipset: slmodemd supporting the snd-hda-intel
>>> audio+modem driver
>>>
>>>  An ALSA (Advanced Linux Sound Architecture) modem driver:  snd-hda-intel
>>>  provides Low Level support enabling contact with the modem hardware.
>>>  For all BUT Conexant chip soft modems (using hsfmodem software)
>>>  complementary High Level support is through a Smartlink utility:
>>>  slmodemd
>>>
>>>  Download from http://linmodems.technion.ac.il/packages/smartlink/
>>>  the package SLMODEMD_gcc4.3_alsa1.0.18.tar.gz having a compiled
>>> slmodemd. Unpack under Linux with:
>>>        $ tar zxf SLMODEMD_gcc4.3_alsa1.0.18.tar.gz
>>>  and read instructions therein. But briefly, the modem is setup with
>>> command:
>>>        sudo slmodemd -c YOUR_COUNTRY --alsa hw:0,6
>>>  reporting dynamic creation of ports:
>>>        /dev/ttySL0 --> /dev/pts/N   , with N some number
>>>  Read DOCs/Smartlink.txt and Modem/DOCs/YourSystem.txt for follow
>>> through guidance.
>>>
>>>
>>> Package that you need is here:
>>>
>>> http://linmodems.technion.ac.il/packages/smartlink/SLMODEMD_gcc4.3_alsa1.0.18.tar.gz
>>>
>>> Download it and follow instructions provided.
>>>
>>> Regards,
>>>
>>> Antonio
>>> On Tue, Apr 5, 2011 at 6:43 AM, the mass <massreg@xxxxxxxxx> wrote:
>>>> Hi
>>>> I have a ASUS F5RL laptop and I want to install its built-in modem in
>>>> Ubuntu 9.04,
>>>> but until now I wasn't able to install it.
>>>>
>>>> I have attached the ModemData.txt file.
>>>>
>>>> Thanks
>>>>
>>>
>>
>



[Linux DVB]     [Asterisk]     [Photo]     [DCCP]     [Netdev]     [Xorg]     [Xfree86]     [Fedora Women]     [Linux USB]

Powered by Linux