Check your Startup folder in the Start menu - if the Adobe Gamma utility shows up there then it runs and loads at startup and you should be fine. You can also re-associate the profile through "My Computer-Control Panel-Display-Settings-Advanced-Color Management" Maris ----- Original Message ----- From: "Andrew Borland" <andrew@hippofarms.freeserve.co.uk> To: <epson-inkjet@leben.com> Sent: Sunday, December 23, 2001 9:18 AM Subject: Deploying Adobe Gamma | I have run the Adobe Gamma utility to characterise my monitor and I | suspect that the resulting "profile" is not being picked up correctly. | If I re-run Adobe Gamma, it always resumes from "Generic EBU 2.2 Gamma | Monitor" rather than my last saved profile. | | I have a Matrox G400 graphics card, which may be relevant, and buried | deep in the Settings|Advanced|ColorManagement tab is a field to | associate profiles with the monitor and this shows only "mnEBUG21" and | not the one created by Adobe Gamma. | | Do I need to add my own profile to that list, and make it the default, | if the results of Adobe Gamma are to be seen on screen? | | Where does one look, in PhotoShop or Windows98, to verify that the | correct profile is being used? | | Thanks in Advance, Andrew Borland (UK) | | | - | Turn off HTML mail features. Keep quoted material short. Use accurate | subject lines. http://www.leben.com/lists for list instructions. - Turn off HTML mail features. Keep quoted material short. Use accurate subject lines. http://www.leben.com/lists for list instructions.