Re: interfacing FPGA to AT91RM9200

["yanjun.luo" <yanjun.luo@xxxxxxxxx>]

Hi Manila,

You can use EBI to connect to FPGA, note that at91rm9200 
only support 16 bit width, you should config SMC registers.

Then you need write a driver to communicate with FPGA or you
can operate with mmap from user space if you don't want 
high performance.

Regards,
Yanjun Luo.





发件人： Manila Goel 
发送时间： 2008-08-14  12:48:17 
收件人： linux-arm@xxxxxxxxxxxxxxxxxxxxxx 
抄送： 
主题： interfacing FPGA to AT91RM9200 
 
Hello All,
I m wrking on at91rm9200 and  i hv to interface  fpga with this. how can i
interface it. Anyone done, plz help how should i proceed? i m new to this.
thanks
Manila
-------------------------------------------------------------------
List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
FAQ:        http://www.arm.linux.org.uk/mailinglists/faq.php
Etiquette:  http://www.arm.linux.org.uk/mailinglists/etiquette.php
-------------------------------------------------------------------List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-armFAQ:        http://www.arm.linux.org.uk/mailinglists/faq.phpEtiquette:  http://www.arm.linux.org.uk/mailinglists/etiquette.php