MXS getting AUART to work with DT.

[Subodh Nijsure <snijsure@xxxxxxxxxxxx>]

Hi,

I am testing my mx28 hardware with arm-soc/for-next branch. I have made  
additions shown below to my dt file.

What I see is only ttyAPP0 device gets created but not the ttyAPP1, do 
folks who know DT much better than I, see any issues with this DT 
definition below?

auart0_pins_a: auart0@0 {
        reg = <0>;
        fsl,pinmux-ids = <0x3000 0x3010 0x3020 0x3030>;
        fsl,drive-strength = <0>;
        fsl,voltage = <1>;
        fsl,pull-up = <0>;
};
auart1_pins_a: auart1@0 {
        reg = <0>;
        fsl,pinmux-ids = <0x3040 0x3050>;
        fsl,drive-strength = <0>;
        fsl,voltage = <1>;
        fsl,pull-up = <0>;
};
auart0: serial@8006a000 {
         pinctrl-names = "default";
         pinctrl-0 = <&auart0_pins_a>;
         status = "okay";
};
auart1: serial@8006c000 {
          pinctrl-names = "default";
          pinctrl-0 = <&auart1_pins_a>;
          status = "okay";
 };

-Subodh

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel