Re: HP-P1006 Laser Printer -

[Joe Zeff <joe@xxxxxxx>]

On 07/22/2012 12:40 PM, Bob Goodwin - Zuni, Virginia, USA wrote:
>     This is Fedora 17/64 XFCE. I have been trying to install a network
>     printer, HP-P1006 Laser Printer. No matter what I do when I get to
>     the end of the process and do a test page nothing prints, it just
>     shows Status: Stopped - Printer  error.
>
>     It seemed to require "hplip.plugin."  I've gone through the install
>     process several times, the last time with "setenforce=0" to no
>     avail. That via the Administration > Printer gui. I also tried CUPS
>     with similar results.

Two things: if you don't have hplip installed, install it and try again. 
 Second, you don't mention any SELinux alerts, which means that it 
isn't a factor.  Automatically disabling SELinux whenever things don't 
go right is worse than waving a dead chicken over the issue; it's cargo 
cult administration.  Yes, there was a time when it would cause problems 
without notice, but that was years ago and the reasons for it have been 
corrected.  I do hope that you've turned it back on!
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org