|
|
|
Re: forced to do text-based F11 install | |
| [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] | |
On Thu, 2009-07-02 at 18:48 -0400, Andre Robatino wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > On 07/02/2009 06:06 PM, Frank Cox wrote: > > On Thu, 02 Jul 2009 17:21:13 -0400 > > Andre Robatino wrote: > > > >> is there a walkthrough > >> anywhere on how to make the resulting system usable? > > > > yum grouplist > > > > Pick the groups you want to install, then > > > > yum groupinstall "name of group" "name of another group" > > > > And so on. > > Good, that sounds not too difficult. Of course, it assumes that > networking is working. Does anyone know how this is done after a > text-based install? "ifup eth0" didn't work. > If you are using NetworkManager you turn the internet on by choosing the eth0 option in the nm-applet in the upper right corner of the panel. If you are running network then use system-config-network and configure the eth0 interface, That is thew same as choosing the System->Administration->Network option Find out which you are running by using the : chkconfig --list |grep <program name> Only one should be running. I would expect by default it is NM. -- ======================================================================= Don't suspect your friends -- turn them in! -- "Brazil" ======================================================================= Aaron Konstam telephone: (210) 656-0355 e-mail: akonstam@xxxxxxxxxxxxx -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
|
|
