> Hi, > > We have a AS1000A that it possesss two SCSI controllers included: Qlisp and > Mylex DAC960 during the installation of Redhat 7.2 it visualized in > diskdruid the Qlisp as sda continued the installation in this device, but > did not visualize the device mylex DAC960, would like to install the device > from the Red HAT, somebody could summarize the steps that I must follow? > > > I find that the device raid already received configurations from the > hardware, therefore was functioning in another system operacional(UNIX). Are you sure that are devices connected to the DAC960 and not only to the QLogic controller!? - yes. I would also suggest to get the arccf.exe utility and check your raid-setting(s). - I believe that raid this ok ( settings), since windows works well with platform , but I go to verify . And why do you still want to use RH7.2? :-) - I tried Fedora Core 3 but it stopped when loading kernel of the CD, with RH7 I did not have problems. What does a show dev in SRM console show you? And a show conf might be of interesst as well... show dev DKA0.0.0.2000.0 DKA0 RZ1CB-CA LYJ0 DKA400.4.0.2000.0 DKA400 RRD45 0436 DRA0.0.0.2003.0 DRA0 3 Member RAID 5 DRA1.0.0.2003.0 DRA1 3 Member RAID 5 DVA0.0.0.1000.0 DVA0 MKA500.5.0.2000.0 MKA500 TLZ09 03a5 EWA0.0.0.12.0 EWA0 00-00-f8-1e-67-14 PKA0.7.0.2000.0 PKA0 SCSI BUS ID7 5.53 Show Conf Firmware: SRMconsole : V5.1-199 ARCconsole: V5.64 PALcode: VMS Palcode V1.20-4 , OSF PALcode V1.22-6 Processor DECchip (Tm) 21164A-1 333MHZ Memory 512 Meg of System Memory Slot Option Hose 0 , BUS 0 , PCI 7 intel 82375 Bridge to bus 1, EISA 8 DECchip 21050-AA Bridge to bus 2, PCI 12 DECchip 21140-AA EWA0.0.0.12.0 00-00-f8-1e-67-14 13 DECchip ZLxp 2i030 Slot Option Hose 0 , BUS 0 , EISA Slot Option Hose 0 , BUS 0 , PCI 0 Qlogic ISP1020 PKA0.7.0.2000.0 SCSI BUS ID7 DKA0.0.0.2000.0 RZ1CB-CA DKA400.4.0.2000.0 RRD45 MKA500.5.0.2000.0 TLZ09 3 Mylex DAC960 DRA.0.0.2003 DRA0.0.0.2003 3 Member RAID 5 DRA1.0.0.2003 3 Member RAID 5 Regards,